VST OneTrack Dokumentacja Pobierz pdf (Strona 312)

100

101

- 312 -

Routing an Audio Channel through Insert Effects

1. Open the Monitor window.

2. Locate the audio channel you want to add insert effects to, and click on

its Insert button.

● For stereo Tracks, there will only be one Insert button, for the left channel in

the audio channel pair. However, both channels in the pair are routed

through the Insert effect (provided it’s a stereo-input effect - see above).

The Insert Effects window opens. This looks much like the Send Effects window,

but has no Effects Master knobs or output bus pop-up menus.

3. Select and activate an Effect, and make settings for it just as with regular

Send Effects.

4. If required, use the parameters in the effect’s control panel to adjust in-

put level and balance between dry and effect signal.

Since the entire signal passes through the effect, you will only hear the “wet”

signal on the output, unless you adjust the settings of the effect to make the

output include some of the “dry” sound as well.

● Not all Effect Plug-ins have dry/wet balance controls.

5. If you want to, repeat steps 2-3 for the other effect processors.

Avoid activating effect processors that you don’t use, since this draws some

extra processor power. To minimize the processor load, pull down the Effect

type pop-up for the unused processors, and select “No Effect”.

• To turn off an Insert Effect, click on its Power button.

1 2 ... 307 308 309 310 311 312 313 314 315 316 317 ... 494 495

Komentarze do niniejszej Instrukcji

Brak uwag

VST OneTrack Dokumentacja Strona 312

Komentarze do niniejszej Instrukcji